Standard motion logic
All standard motion logics available for highly flexible combination and utilization as needed
The modularization of mechanical engineering functions – accelerate TTM and improve machine stability
Electronic cam shape design and dynamic switching allows for switching motion curves in a cycle to seamlessly connect machine motions
Position control, acceleration control, deceleration control, speed control
"Connect" and "disconnect" actions of multiple curves
Simulation of multiple master axes for follower control
Unlimited expansion of virtual master axes
Slave axis following master axis control
Slave axis can freely switch between follower axes
Multi-axis phase synchronization
Multi-axis speed synchronization
Speed and phase synchronization
Generate any motion curve based on conditions used
Up to 4 motion curves can be generated for a single axis. Free switching is enabled.
Straight line interpolation control
Curve interpolation control
Optimized control for multi-axis with motion routes
Load cell feedback correction tension
Constant or automatically calculated tension
Correction amount limitation
Roll up/off direction can be changed
Roll up diameter calculation
Roll up friction compensation
Constant fixed tension under static state
Roll up acceleration/deceleration tension compensation
Precision calculation of PID correction control
Multi-mode selection control
Select appropriate algorism based on mechanical design
Single-axis cam synchronous control
Follower axis cam synchronous control
Marker correction control
Sag feed control for discontinuous feed
Sag swing position upper/lower limit setting
Center roll off control / peripheral roll off control
Synchronization speed control
Synchronization time control
Synchronization curve switching control
Marker correction control
Precision sealing of a single product at different locations
Continuous following sealing
English 
繁體中文 
